MDPE Straight Joiner 25mm to 1" BSPM is a compression fitting that adapts a 25mm MDPE pipe to a 1" BSP male thread, delivering a neat, straight inline connection for water, irrigation and industrial piping. Designed for on-site tradespeople, it offers a reliable seal without the need for specialist tools. Key benefits - Pressure rating: PN10 MDPE fittings are rated up to 10 bar (approximately 1 MPa / 145 psi), suitable for typical domestic and light industrial systems. - Material resilience: MDPE provides good chemical resistance and durability, helping protect against corrosion and long-term wear. - Leak-free joints: When installed properly, compression connections are designed to form tight, reliable seals. - Durability and versatility: Built to withstand temperature variations and mechanical stress, suitable for water supply, irrigation, gas distribution and certain industrial applications. - Straight connection: The 25mm to 1" BSPM configuration supports direct, in-line runs without angle changes, reducing potential leakage points. - Simple installation: No heat or solvent welding required; just tighten the compression sleeve onto the MDPE pipe and threaded festa on the BSP side. Ideal uses - Domestic water supply lines bridging MDPE mains to appliances or manifolds - Irrigation systems where 25mm MDPE pipes must join to a threaded fitting for valves or manifolds - Light industrial pipes needing a straightforward 25mm to BSP connection - Retrofitting or repairs where pipe ends are cut cleanly and threaded connections are preferred Installation notes - Ensure MDPE pipe ends are cut square and deburred for a clean seal. - Verify the 25mm pipe fits correctly into the compression sleeve and that the BSP male thread is clean and undamaged. - Tighten the compression nut and check for leaks after commissioning. If leakage occurs, re-tighten within recommended torque range and inspect pipe ends. Specifications - Fitting type: MDPE Straight Joiner compression fitting - Connection: 25mm pipe to 1" BSP male thread - Material: MDPE - Pressure rating: PN10 - Applications: water supply, irrigation, gas distribution and industrial piping (where MDPE PN10 is suitable)